How to Use the Michael Todd Microdermabrasion Tip (Microsmooth) on the Sonicsmooth Pro+

Holding a dermaplaning tool against the forehead during an at home dermaplaning pass
Disclosure This post contains affiliate links, which means I may earn a small commission if you make a purchase through my links, at no extra cost to you.

Here is how to use the Michael Todd microdermabrasion tip: swap the dermaplaning blade on your Sonicsmooth for a Microsmooth diamond tip, cleanse and dry your face, pick a speed, hold the tip at a 45 degree angle starting near the hairline, and make short strokes that follow the contours of your face, one to three passes per area. Michael Todd Beauty recommends it once a week, as an in-between step a few days after your weekly dermaplaning session, not on the same day. If you want microdermabrasion with suction and pore extraction instead of a tip on your dermaplaning tool, that is a different device, the Sonic Refresher, covered further down.

Check the Sonicsmooth Pro+ (comes with 2 Microsmooth tips) on Amazon

The short version

  • What it is: Microsmooth is a diamond microdermabrasion tip that attaches to the Sonicsmooth in place of the blade. It buffs away dead skin with fine diamond particles and uses sonic vibration rather than suction.
  • Where to get it: two Microsmooth tips come in the box with the Sonicsmooth Pro+, and replacement two-packs are sold separately.
  • How often: once a week, as the brand puts it, an intermediate treatment between weekly Sonicsmooth sessions.
  • How: clean, dry skin, 45 degree angle, short strokes along the contours, one to three passes per area, then serum or moisturizer.
  • Not the same as the Sonic Refresher: that is Michael Todd’s standalone wet/dry microdermabrasion system with suction pore extraction and a mist. Different device, different steps.

Which Michael Todd microdermabrasion do you have?

Searches for “Michael Todd microdermabrasion” can mean either of two products, and the instructions are not interchangeable. Check this first.

Microsmooth tipSonic Refresher
What it isA diamond microdermabrasion tip for the Sonicsmooth dermaplaning deviceA standalone wet/dry sonic microdermabrasion and pore extraction system
How it exfoliatesLaser-cut diamond bits with sonic vibration, no suctionDiamond heads plus vacuum suction
HeadsOne tip that swaps in for the blade, sold in two-packsCoarse, fine and small fine diamond heads, plus three pore extraction heads
ExtrasNone, it rides on the SonicsmoothNano mist for water or toner, 40 disposable filters, charging cradle
SpeedsThe Sonicsmooth’s 3 speedsMultiple speeds shown on an LCD
Brand’s frequencyOnce a week, between weekly dermaplaning sessionsOnce a week
Where it sellsIn the Sonicsmooth Pro+ box, and as a two-pack on AmazonMichael Todd Beauty’s own site
Best forAnyone who already dermaplanes with a SonicsmoothAnyone who wants pore extraction and does not dermaplane

If you already own a Sonicsmooth Pro+, look in the box before you buy anything. The two Microsmooth tips are the small diamond-coated heads packed alongside the 16 dermaplaning blades.

Two Michael Todd Beauty Microsmooth diamond microdermabrasion tips for the Sonicsmooth
The Microsmooth tips: diamond-coated heads that go on the Sonicsmooth in place of the blade. Image: Michael Todd Beauty.

How to use the Microsmooth microdermabrasion tip, step by step

  1. Swap the blade for the tip. Remove the dermaplaning blade from the Sonicsmooth and attach a Microsmooth tip in its place. Make sure it is firmly seated before you turn the device on.
  2. Cleanse with an oil-free cleanser. Rinse well and pat your face completely dry. The tip works on bare, dry skin, so skip oils and serums until the end.
  3. Pick a speed. The Sonicsmooth has three. Start on the lowest setting the first few times and move up only if your skin is comfortable.
  4. Hold the tip at a 45 degree angle. Start near the hairline and work down the face in sections.
  5. Use short strokes that follow your contours. Forehead, cheeks, along the jaw and chin. Keep the tip moving and let it glide rather than pressing it in.
  6. One to three passes per area. That is the brand’s range. One pass is plenty for a first session.
  7. Follow with serum or moisturizer. Freshly exfoliated skin is the point where your skincare goes on most evenly. The Pro+ listing also advises holding off on makeup right after using the device.
  8. Clean the tip. Take it off the device, rinse it under warm water, and let it air dry before you put it away.

Need replacements? See the Microsmooth replacement tips two-pack on Amazon. The listing describes them as compatible with the Sonicsmooth system, device not included.

How Microsmooth fits with your dermaplaning week

The blade and the diamond tip do different jobs. The blade shaves off peach fuzz and the top layer of dead skin. The Microsmooth tip only buffs. Michael Todd Beauty positions Microsmooth as the step in between weekly Sonicsmooth sessions, and its how-to page suggests using the Microsmooth tips two to three days after you dermaplane. Its support article puts the Microsmooth frequency at once a week.

A simple rhythm that follows the brand’s guidance:

Do not stack both on the same day. Two exfoliating steps back to back is the fastest way to end up red and tight. If your skin still feels sensitive from dermaplaning, skip the Microsmooth that week.

The video below walks through the Sonicsmooth Pro+ dermaplaning routine that the Microsmooth step builds on.

At Home Dermaplane Tutorial Using Michael Todd Beauty Sonicsmooth Pro+

Who should go slow or skip it

  • Sensitive skin: the brand says Microsmooth suits all skin types, including sensitive skin, and that the speed setting lets you adjust the intensity. The move is the lowest speed and a single pass.
  • Irritated, broken or sunburned skin, or an active breakout: work around those areas or wait until they settle.
  • A skin condition or prescription skincare: check with a dermatologist before adding any exfoliating tool. Michael Todd’s own Sonic Refresher guide says the same for anyone under a doctor’s care for a skin condition or with very sensitive skin.
  • Around the eyes: stay off the thin skin there.

More on what dermatologists say about exfoliating at home is in Is At-Home Dermaplaning Safe?, and the after-routine is in What to Use After Dermaplaning.

How to use the Michael Todd Sonic Refresher instead

If the device in your hands has a mist reservoir and suction heads, it is the Sonic Refresher. The quick start guide lays out a five-step routine, each step using the same glide technique.

  1. Prep: charge it fully before the first use, test on a small area, cleanse and pat dry, and put a new disposable filter under the head.
  2. Renew, coarse tip: short upward and outward strokes on the face. Keep it away from the thin skin around the eyes and lips.
  3. Reset, small tip: the tight spots, around the nose, mouth lines, crow’s feet, between the brows and the forehead.
  4. Refine, fine tip: a final polish before skincare or makeup.
  5. Remove, pore extraction tip: suction lifts out congestion. Keep it moving the whole time.
  6. Rehydrate: fill the reservoir with water or toner and mist. No oil-based products in the mister.

Technique for every step: work in one to two inch sections, hold the skin taut with your free hand, start on low speed, and begin with two to four passes, moving up to four to six once your skin is used to it. Never hold it still on one spot. The brand’s support article puts the Sonic Refresher at once a week. The guide also notes the device contains magnets, so keep it away from pacemakers and other implanted devices.

The Sonic Refresher does not show up on Amazon. It sells on Michael Todd Beauty’s site, with a 30-day money-back guarantee and a 3-year warranty listed on the page.

Which one to buy

Still deciding on a dermaplaning tool in the first place? See the Michael Todd Sonicsmooth Pro+ review and how it stacks up in Dermaflash vs Michael Todd.

FAQ

How do you use the Michael Todd microdermabrasion tip?

Swap the blade on your Sonicsmooth for a Microsmooth tip, cleanse with an oil-free cleanser and pat dry, choose a speed, then hold the tip at a 45 degree angle starting near the hairline and make short strokes along the contours of your face, one to three passes per area. Finish with serum or moisturizer.

How often can you use Michael Todd microdermabrasion?

Michael Todd Beauty recommends once a week for both the Microsmooth tip and the Sonic Refresher. For Microsmooth, the brand places it between weekly dermaplaning sessions, a few days after you use the blade.

Can you dermaplane and use the Microsmooth tip on the same day?

The brand frames Microsmooth as an in-between treatment, and its how-to page suggests the tips two to three days after dermaplaning. Spacing them out keeps you from exfoliating twice in one session.

Does the Sonicsmooth Pro+ come with microdermabrasion tips?

Yes. The Pro+ listing includes 16 dermaplaning blades and 2 Microsmooth exfoliation tips. Replacement Microsmooth tips are sold in two-packs.

Is Michael Todd microdermabrasion safe for sensitive skin?

The brand says both Microsmooth and the Sonic Refresher suit all skin types, including sensitive skin, with speed settings to adjust intensity. Start on the lowest speed with a single pass. If you have a skin condition or very sensitive skin, check with a dermatologist first.

How do you clean the Microsmooth tip?

Remove it from the device, rinse it under warm water after every use, and let it air dry.

Comments

Leave a Reply

Your email address will not be published. Required fields are marked *